• EI
  • Scopus
  • 中国科技期刊卓越行动计划项目资助期刊
  • 北大核心期刊
  • DOAJ
  • EBSCO
  • 中国核心学术期刊RCCSE A+
  • 中国精品科技期刊
  • JST China
  • FSTA
  • 中国农林核心期刊
  • 中国科技核心期刊CSTPCD
  • CA
  • WJCI
  • 食品科学与工程领域高质量科技期刊分级目录第一方阵T1
中国精品科技期刊2020
孙长霞, 苏印泉, 张柏林. 响应面分析法优化松萝多糖提取工艺的研究[J]. 食品工业科技, 2014, (05): 196-201. DOI: 10.13386/j.issn1002-0306.2014.05.027
引用本文: 孙长霞, 苏印泉, 张柏林. 响应面分析法优化松萝多糖提取工艺的研究[J]. 食品工业科技, 2014, (05): 196-201. DOI: 10.13386/j.issn1002-0306.2014.05.027
SUN Chang-xia, SU Yin-quan, ZHANG Bo-lin. Optimization of the extraction technique of Usnea Polysaccharide via response surface analysis[J]. Science and Technology of Food Industry, 2014, (05): 196-201. DOI: 10.13386/j.issn1002-0306.2014.05.027
Citation: SUN Chang-xia, SU Yin-quan, ZHANG Bo-lin. Optimization of the extraction technique of Usnea Polysaccharide via response surface analysis[J]. Science and Technology of Food Industry, 2014, (05): 196-201. DOI: 10.13386/j.issn1002-0306.2014.05.027

响应面分析法优化松萝多糖提取工艺的研究

Optimization of the extraction technique of Usnea Polysaccharide via response surface analysis

  • 摘要: 采用响应面分析法优化了粗皮松萝(Usnea.montis-fuji)多糖的提取条件。在单因素实验基础上,选取提取温度、提取时间和液/料比为关键因素,根据central composite design(CCD)的中心组合原理设计实验,采用响应面分析法对粗皮松萝多糖的关键参数进行了优化研究,建立了松萝多糖提取含量的数学模型。结果表明:三个因素对松萝多糖提取含量的影响大小依次是提取时间>液/料比>提取温度;松萝多糖提取的最佳工艺参数:提取温度80℃,提取时间3.00h,液/料比40∶1。在此条件下,松萝粗多糖提取含量达到80.16mg/g,在最优条件下进行了验证实验,得到的实验结果与模型预测值比较吻合,验证了数学模型的有效性。 

     

    Abstract: In this paper, aiming at the extraction of Usnea polysaccharide, response surface methodology ( RSM) with 3 factors and 3 levels was adopted to study the key parameters in order to increase the yield of Usnea polysaccharide. A second order quadratic equation was established, and the applicability of the model was verified.The results showed that the effect order of three factors on the yields of Usnea polysaccharide were as follows: extraction time, extraction temperature and ratio of sample to water. The optimum conditions of Usnea polysaccharide extraction were: the extraction temperature of 80℃, extraction time of 3.00h, ratio of sample to water of 40∶1. Under the optimization conditions the yield of Usnea polysaccharide reached 80.16mg /g, meanwhile the results indicated that the feasible model fitted well with the experimental data.

     

/

返回文章
返回